Dependable range repair for dual-fuel and gas ranges across Larchmont and the surrounding metro.
Dual-fuel and gas ranges are the workhorses of the kitchens we serve, and their faults split cleanly between the cooktop and the oven. On the cooktop, a burner that clicks without lighting is almost always a shifted cap or a fouled igniter rather than a failed burner. In the oven, a gas igniter that has weakened cannot draw enough current to open the safety valve, so the oven clicks, smells faintly of gas, or heats slowly and falls short.
On dual-fuel models the electric oven adds bake and broil elements and a relay board to the picture, along with the temperature sensor that keeps the setpoint honest. We measure igniter draw, element continuity, and sensor resistance so the repair lands on the one part that has actually failed, then confirm an even, accurate bake before we finish.
What We Fix
- Surface-burner igniter and valve service
- Oven bake and broil element replacement
- Convection fan and motor repair
- Spark-module and ignition-switch service
- Temperature calibration and sensor replacement
Have a range problem?
Common Problems
- A surface burner clicking but never lighting
- An oven that will not reach or hold temperature
- Baking that comes out uneven or with hot spots
- A burner flame that stays low or uneven
- An oven door that will not seal or a self-clean fault
Typical Causes
- Clogged burner ports or a wet igniter cap
- A failed spark module or ignition switch
- A weak or open oven igniter on gas models
- An oven sensor reading high or low
- A convection fan motor disrupting airflow
Brands We Service
We service dual-fuel and gas ranges across every brand in our roster. On the range side that means Sub-Zero and Wolf work most, alongside Thermador, Miele, Bosch, and the rest of the luxury lineup.
Error and Fault Reference
Below are the indications we meet most on dual-fuel and gas ranges. Each one narrows the range to a circuit, and we confirm the true cause with hands-on testing before a part goes in.
| Code | What It Means | What We Check |
|---|---|---|
F1 / F7 | Control or keypad fault | Test the keypad, then the control board |
F3 / F4 | Oven sensor open or shorted | Measure the sensor and inspect wiring |
Ignition | A burner that will not spark | Check the spark module, switch, and electrode |